Maxair CAPR User Instructions page 62

Replacing a DLC for continued use with the Helmet donned
1. Obtain the correct replacement
DLC from the corresponding DLC
dispensing Box.
4. Align and snap the DLC Front
Alignment Hole over the Helmet Front
Alignment Post.
WARNING
After donning, if conditions 1
and 2 both are not achieved,
switch to the other size DLC
and repeat steps 1 through 6
above.
Page 62 P/N 03521015 Rev Q
2. Pull the DLC Peel Tab up, over
and to the left to remove the Lens
Protective Cover off the Lens.
5. Align and Snap the other DLC Side
Attachment Hole over the other FCC
Side Attachment Post.
Condition 1: Ensure the DLC
Flappers are away from the Lens,
positioned perpendicular to your
temples, and within ¼ inch of the
temples on each side of the head.
3. Align and snap one DLC
Side Attachment Hole over
the respective FCC Side
Attachment Post.
6. Slide your fingers between the Cuff
and face from each temple down
and under your chin to pull the DLC
Flappers away from the lens, and to
properly position the cuff.
Condition 2: Ensure slight tension
on the cuff is felt continuously while
sliding the index or first finger between
the cuff and the face all along the chin
and up to the temples, from the right
side of the face to the left.