Maxair CAPR User Instructions page 86

NOTE
Read Sections 1 through 11 before proceeding.
NOTE
The 2270-06 HE Hood may be used alternatively with the 2082-03 Helmet or the 2026-03 Helmet. Due to the
extreme between the Helmets, photos are of the 2082-03 unless 2026-03 photos are needed for clarity.
Prep for Donning:
1. Remove Hood and Heavy Loading Filter from packaging and lay on a
counter with labels facing up.
3. Connect the Battery to the Belt and place the Belt around the
waist, typically with the Battery towards the rear of the right hip.
To begin air flow, insert the Helmet Power Cord Connector into
Battery Connector receptacle until the Secure Lock audibly clicks.
Don:
4. Turn Headband Ratchet Knob
counterclockwise to loosen
headband for ease of donning
Helmet.
Page 86 P/N 03521015 Rev Q
waist before donning the battery, and then completed, or
fully after the battery is donned and connected.
< 1/2 inch (~ 12.7 mm)
5. Position Helmet on head with front
Headband within 1/2 inch of eyebrows.
2. Refer to the 2367-02 Quick Cuff IFU for
Quick Cuff to Helmet assembly instructions.
NOTE
The outer gown may be donned up to about the
NOTE
Depending
on the anticipated
comfort level when
fully gowned, the
Helmet Air-Flow
Level may be set to
Med of High.
6. Turn Ratchet Knob clockwise to tighten
Headband as tight as comfortable to
secure Helmet to Head for all
anticipated activities.