Maxair CAPR User Instructions page 65

There are two alternative protocols for doffing the CAPR Helmet:
•
Alternative A is doffing the Helmet leaving the DLC attached for the next use.
•
Alternative B is for removing the DLC for disposal and then doffing the Helmet.
Doffing the System: Alternative A
1. Loosen the rear Headband
Adjustment Knob (turn
counterclockwise).
4. Disconnect the Battery Belt from
around the waist by un-snapping
the buckle.
7. If desired, all components
of the CAPR System may
be disassembled and each
component decontaminated,
cleaned and/or stored at this
time.
Page 65 P/N 03521015 Rev Q
2. Hold the front top of the Helmet in one
hand and with the other hand on the
Adjustment Knob; lift the Helmet up and
off the head
5. With the Charger connected to the
mains wall power, connect the Charger
Cord to the Battery. Push the Charger
Cord Connector into the Battery
Receptacle until it is fully seated.
3. Disconnect the Helmet Power Cord
from the Battery - push the Secure
Connection Button down, pull Cord
Connector out, release the Button.
6. The entire CAPR System may be
decontaminated, cleaned and/or
stored at this time.