Filter Cover Cap (Fcc) - Maxair CAPR User Instructions

13. Filter Cover Cap (FCC)

The Filter Cover Cap, 2061-08 (01031284) provides protection for MAXAIR Filter Cartridges in various Cuff and Shroud
configurations.
WARNING
Never mount a FCC on a Helmet until a fully functional Filter Cartridge is securely in place on the Helmet.
CAUTION
Prior to assembly, visually inspect the perimeter of the Helmet and verify the white edges
are tucked inside the clear edges. If not, manually tuck the Helmet outer shell white
edges under and inside of the Helmet inner shell clear lip - all around the Helmet.
Asssembly
1. Align the Helmet Front Adapter to
the indentation on the inside of the
FCC Front Adapter.
5. Ensure that each FCC Side Adapter is snapped fully down over each Helmet Side
Adapter.
Page 57 P/N 03521015 Rev Q
2. Hold the Helmet/Liner/ Filter Cartridge
upright by its rear underside with one hand,
insert the Helmet Front Adapter into the
inside of the FCC Front Adapter, and pull the
FCC , back, over and down onto the Helmet.
4. Ensure that the T-Tab is fully snapped down on the Helmet rear
Bottom Snap (use thumb if necessary to press in place).
A
B
3. Pull the FCC fully down on the
Helmet (Squeeze together) to
align the FCC T-Tab hole (A)
over the Helmet rear Bottom
Snap (B).
T-Tab