Maxair CAPR User Instructions page 78

Donning
`
9. Connect the Helmet Power Cord to the Battery. Push
the Power Cord Connector into the Battery Receptacle
until the Secure Connection audibly clicks.
12. Pull Helmet over and
down onto head.
≤ 1/2 inch
(~1.25 cm)
16. Ensure that the front
Headband is within
1/2 inch of eyebrows
for good visualization
of the Safety LEDs
Doffing
Reverse steps 9 thru 19 to doff Helmet and remove Hood.
After disconnecting the Battery from the Helmet, connect
it to the Charger.
Page 78 P/N 03521015 Rev Q
13. Secure Helmet by
tightening Ratchet
Knob as tight as
comfortably possible,
while ensuring stability.
17. Pull lower ties around
from back and place
through tie slits in hood
bottom. Tie securely.
10. Loosen rear Ratchet Knob
(counterclockwise).
14. Pull back of Hood over, and
down behind Helmet.
18. Pull upper ties around and to
front and tie securely under
Lens. Ties should be within
about 1/2 inch from neck.
WARNING
Refer to Section 9, page 43, Instructions For
Use: Charger, for details on proper use of
chargers and for charging batteries.
11. Hold Helmet in one
hand; pull Cuff down
with other hand, and
place chin into Cuff.
15. Slide fingers between
face and Cuff on both
sides from chin to
temples to ensure
slight Cuff-to-face
tension*.
19. Suitable body
cover gown is
recommended. Tuck
Hood Shroud under
body cover gown for
optimum protection.