Hardware Installation
The LiteBeam was designed for outdoor use and quick
mounting on a pole.
1. Hold the Center Reflector Panel by hand (do not use a
tabletop or flat surface) and insert the Rear Housing:
WARNING:
the Center Reflector Panel by pushing down onto a
tabletop or other flat surface as this can deform the
panel. Hold the Center Reflector Panel by hand.
a. Line up the three snap hooks and two mounting studs
of the Rear Housing with the corresponding slots and
holes of the Center Reflector Panel.
b. Press the top snap hook into the top slot until it locks
into place.
Do not install the Rear Housing into