Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Ubiquiti Lite Beam AC LR LBE-5AC-LR
Summary of Contents for Ubiquiti Lite Beam AC LR LBE-5AC-LR
- Page 1 5 GHz airMAX AC Long-Range ® CPE with InnerFeed Technology ® Model: LBE-5AC-LR...
- Page 2 (Qty. 3) (24V, 0.3A) with Mounting Bracket TERMS OF USE: Ubiquiti radio devices must be professionally installed. Shielded Ethernet cable and earth grounding must be used as conditions of product warranty. TOUGHCable ™ designed for outdoor installations. It is the professional installer’s responsibility to follow local country regulations, including operation within legal frequency channels, output power, and Dynamic Frequency Selection (DFS) requirements.
-
Page 3: Installation Requirements
AC ground of the PoE. We recommend that you protect your networks from harmful outdoor environments and destructive ESD events with industrial‑grade, shielded Ethernet cable from Ubiquiti Networks. For more details, visit www.ubnt.com/toughcable • Surge protection should be used for all outdoor installations. -
Page 4: Application Examples
Application Examples The LiteBeam mounted outdoors with the reflector installed provides directional outdoor coverage (gain reflector‑dependent). The LiteBeam mounted outdoors without the reflector installed provides outdoor‑to‑indoor coverage using the 3 dBi Antenna Feed only. -
Page 5: Hardware Overview
Hardware Overview Bottom View LEDs Technology Reset Button Ethernet Port Antenna Feed Reflector Assembly Port Cover Feed Receiver Side Plates Mounting Bracket... - Page 6 LEDs Ethernet The LED will light steady blue when an active Ethernet connection is made and flash when there is activity. Power The LED will light blue when the device is connected to a power source. Button Reset To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the LiteBeam is powered on.
-
Page 7: Hardware Installation
Hardware Installation The LiteBeam was designed for outdoor use and quick mounting on a pole. 1. Assemble the antenna reflector by attaching the Side Reflector Panels to the Center Reflector Panel: a. Insert the two locating pins on the Center Reflector Panel into the corresponding holes of the Side Reflector Panel. - Page 8 2. Use two Screws to fasten each Side Plate to the panel assembly.
- Page 9 3. Hold the reflector assembly by hand (do not use a tabletop or flat surface) and insert the Feed Receiver: a. Line up the three snap hooks and two mounting studs of the Feed Receiver with the corresponding slots and holes of the Center Reflector Panel.
Need help?
Do you have a question about the Lite Beam AC LR LBE-5AC-LR and is the answer not in the manual?
Questions and answers