Inventory; Helm Seat; 12V Dc Systems - Back Cove Yachts Back Cove 30 Owner's Manual

1. Inventory

Inventory all equipment and report all shortages.

2. Helm Seat

Check installation of seat and pedestal.

3. 12V DC Systems

Turn "ON" Ship's service (house) battery ON/OFF switch located on the starboard
face of the companionway.
Check the voltage of the Ship's service (house) batteries using the voltmeter at the
12V DC electrical distribution panel (meter position 2) located on the bulkhead aft of
the Galley on the starboard side. Charge the ship's service (house) batteries, if
necessary.
Note: Meter position 3 is not used.
Try each circuit for function.
Turn "ON" helm instruments breaker at the 12V DC electrical distribution panel. This
powers all breakers on the helm panels. With the exception of courtesy lights, these
are wired to 24-hour power.
Test wipers, washers, horn, engine room blower and trim tabs.
Note: Windshield washers require the Fresh Water breaker to be in the "ON" position.
Note: Port trim tab switch operates starboard trim tab, starboard trim tab switch operates port
trim tab.
Test running lights and anchor light.
Check operation of bilge pump switches.
Note: the bilge pumps are wired to bypass the 12V DC battery switch and stay activated when
the 12V DC Battery switch is "OFF".
Check operation of head and engine room blowers.
Check electric engine room hatch lift.
Check operation of other 12V DC circuits. Read owner's manuals supplied.
Page 2 of 10