Table of Contents
Advertisement
11
SERVICE MODE
To access service mode, you need to have a terminal program installed on your PC like e.g. Termite or the old
Hyperterminal. Connect the LOGBOX SE via USB to the PC and connect your terminal program to the right COM port. The
serial settings aren't really important.
Or attach the Serial2 port of the LOGBOX SE using RS-232 and when applicable an RS-232 – RS-485 converter. Then serial
settings do matter of course.
Type Service at the bottom of the Termite window.
Now a wide range of commands is possible. Normally one would not need them as they offer no advantages over the
LOGBOXSESetup program apart from a forced Reset and switching on the GSM modem for testing and sending test emails.
Commands are Case sensitive.
After a few minutes Service Mode will be exited automatically.
31
Advertisement
Table of Contents
