Table of Contents
Advertisement
7
QUICK START
The LOGBOX SE is supplied ready for use. After unpacking it is necessary to open the case by unscrewing the four screws.
With the switch in Off position now connect a power supply in the range of 4...20Vdc to POWER or CHARGER or the lead
acid battery to BATT. For mobile power supply there is the holder for six AA type batteries that needs to be connected to
POWER with the BATT jumper removed for the lowest power consumption possible.
Last step is to connect the supplied USB cable with the computer. The LOGBOX SE Setup software can be used to setup
the logger and related sensors. Do not switch the LOGBOX SE on yet. The USB connection or 6 AA batteries can both supply
the board enough electrical power to perform the setup.
The screw terminals for wire connections can easily be removed from the printed circuit board. Thus making
cable screw down easier and preventing the printed circuit board from being damaged.
11
Advertisement
Table of Contents
