Table of Contents
Advertisement
Pressing OK will select that line and underline the selected value. Up/Down keys will then scroll
through the available options. Pressing OK again will select the displayed value. (underline will
disappear)
12 Operation mode
When the USB cable is connected at power on, or during operation and logging is off, the menu asks
you to select between:
12.1 PC communication
This sets normal operation with the possibility to use the Meteon 2.0 PC software. See chapter
16 for a detailed description.
12.2 Transparent
This sets the Meteon to act just as an RS485 to USB interface. In this mode the Meteon
functionality and Meteon PC software are not functional. However it does allow the use of K&Z Smart
sensors such as SMP pyranometers to communicate with the SmartExplorer software. After selecting
this option the Meteon asks you if (sensor) power is required from the Meteon, or not. If your
radiometer has no other power source, select Yes.
METEON 2.0
2019-01-09
Configuration
-
Measurement
-
Device setting
The top line shows USB and DC power connected. When on batteries, the DC indicator is replaced with
a battery symbol. 4 lines in the battery symbol means battery is full, 1 line means batteries needs to be
replaced. With batteries below 5.5V the Meteon will not start and show battery empty in the start
menu.
13 Configuration
13.1 Modbus setting
In the configuration menu the Modbus and sensor settings can be adjusted. Make sure all connected
Modbus sensors are enabled, have power, are set to the same communication parameters but have
different Modbus addresses. When transferring new settings to a Modbus sensor, only one sensor can
be connected.
09:10
USB DC
15
Advertisement
Table of Contents
