Froggit IP Observer WH2600 SE Operating Instructions Manual page 54

7.2 Measurement Specifications
The following table provides the specifications for the measured parameters.
Measurement
Indoor Temperature
Outdoor
Temperature
Indoor Humidity
Outdoor Humidity
Barometric
Pressure
Light
Rain
Wind Direction
Wind Speed
7.3 Power Consumption
•
ObserverIp Receiver : 5V DC Adaptor (included)
•
Indoor Thermo-hygrometer-barometer sensor : 2xAAA batteries (not included)
•
Outdoor sensor array: 3xAA alkaline batteries (not included)
1. Maintenance
1. Clean the rain gauge once every 3 months as follows. Reference Figure 23.
Step 1: Make a note of the current rain totals by referencing the calibration panel
(reference Section 0). You will need to re-enter these values after the calibration
procedure
Step 2: Pour water into the rain collector to moisturize the dirt inside rain bucket.
Step 3: Use an approximately 3 inch (80 mm) long cotton swab, and push the cotton
tip through the rain collector hole until is reaches the self emptying mechanism, and
press
Step 4: Rotate the cotton swab back and forth, removing dirt from the tipping
mechanism
Range
0 to 60 °C
-40 to 65 °C sensor
-5 to 60 °C battery range
(alkaline)
1 to 99%
1 to 99%
300-1100hPa
(8.85 to 32.50 inHg)
0 to 400,000 Lux
0 – 9999mm
0 - 360 º
0-50m/s
until the
and
Accuracy
± 1 °C
± 1 °C
± 5%
± 5%
+/-3hpa under 700-
1100hPa
± 20%
± 10%
10º
± 1m/s or 10% (whichever
is greater)
it
mechanism no
rain
54
Resolution
0.1 °C
0.1 °C
1 %
1 %
0.1hPa
1 Lux
0.03mm
1º
0.1 m/s
complete.
longer rotates.
collector hole.