Reversible Access Door - Hatco FLAV-R-FRESH FDWD Series Installation And Operating Manual

INSTALLATION

REVERSIBLE ACCESS DOOR

The Flav-R-Fresh access door may be hinged on
®
either the left or right side for your convenience (see
Figure 7.). Use the following procedure to reverse
the door hinges.
1. Remove the top hinge pin screw holding the door
to the hinge. Remove the nylon washer.
2. Tip the door assembly forward (away from
cabinet) and lift gently to clear the bottom hinge
assembly. Remove the two nylon washers.
3. Reinstall the hinge pin screw that was removed
in Step 1.
4. Remove the screws holding the hinges to the
cabinet.
5. Remove the screws from the striker plates on the
non-hinge side of the cabinet.
6. Install the striker plates on the opposite side of
the cabinet where the hinges were previously
mounted.
Hinge Pin Screw
and Nylon Washer
Hinge Pin Screw
and Nylon Washers
All manuals and user guides at all-guides.com
Hinge Assembly
Glass Door
Figure 7. Reversible Access Door
6
7. Install the hinges on the opposite side of the
cabinet where the striker plates were previously
mounted using the original hinge mounting
screws.
8. Carefully rotate the door 180°.
9. Remove the hinge pin screw from the end that is
now the top.
10.Carefully place the door assembly with the two
nylon washers into the bottom hinge.
11. Tip/tilt the door assembly towards the cabinet
and align the door top with the hinge. With the
nylon washer between the door top and the
hinge, reinstall the door hinge pin screw through
the hinge and into the door top.
Striker Plate
Form No. FDWDM-1207