Table of Contents
Advertisement
UNPACKING
The Flav-R-Fresh
Holding and Display Cabinets
®
are shipped with most components installed and
ready for operation. The following installation
instructions must be performed before plugging in
and operating the cabinet.
1. Remove unit from box.
2. Remove information packet. To prevent delay
in obtaining warranty coverage, fill out and
mail in the warranty card.
3. Remove tape and protective packaging from all
surfaces of unit.
Floor Sheet
The stainless steel floor in all Flav-R-Fresh
cabinets is protected during shipping with a sheet of
corrugated cardboard. This protection must be
removed prior to cabinet operation.
Display Racks
The display racks have packing material and
cardboard attached for protection during shipping.
This protection must be removed prior to cabinet
operation.
Legs
The Flav-R-Fresh
cabinets are shipped with four 1"
®
(25 mm) metal screw-type feet attached to the
bottom of the unit. For cabinets with the optional 4"
(102 mm) Adjustable Legs, see the ACCESSORIES
section for installation instructions.
Glass Panels
The Flav-R-Fresh
cabinets have tempered glass
®
panels that are protected during shipping by rubber
tabs along the glass edges and tape to securely
hold the panels (see Figure 6.). These tabs and
tape must be removed prior to cabinet operation.
NOTE: If installing 4" (102 mm) legs, do not remove
glass protection until leg installation is
complete. See the ACCESSORIES section
for installation instructions.
Rubber Tab
Figure 6. Shipping Tab for Glass Panels
Form No. FDWDM-1207
All manuals and user guides at all-guides.com
®
LOCATION
To avoid any injury or damage, locate the
display cabinet at the proper counter height in
an area that is convenient for use. The location
should be level to prevent the unit or its
contents from accidentally falling and strong
enough to support the weight of the unit and
food.
For safe and proper operation, the display
cabinet must be located 2" (51 mm) from
combustible walls and materials. If safe
distances are not maintained, discoloration or
combustion could occur.
Unit is not weatherproof. For safe and proper
operation, locate the unit indoors where the
ambient air temperature is a minimum of 70°F
(21°C).
The unit must be transported in an upright
position. Before moving or tipping the unit,
secure all glass surfaces with tape. The water
also must be drained from the unit. Failure to do
so may result in damage to the unit or personal
injury.
5
INSTALLATION
CAUTION
WARNING
CAUTION
CAUTION
Advertisement
Table of Contents
