Table of Contents
Advertisement
6 Unpacking, installation and commissioning
6.1 Place of installation, place of use
The balance is constructed in such a way that reliable weighing results can be
achieved under normal application conditions.
By selecting the correct location for your balance, you will be able to work quickly and
precisely.
Therefore please observe the following at the place of installation:
Place the balance on a firm, level surface;
-
Avoid extreme heat as well as temperature fluctuation caused by installing
-
next to a radiator or in the direct sunlight;
Protect the balance against direct draughts due to open windows and doors;
-
Avoid jarring during weighing;
-
Protect the balance against high humidity, vapours and dust;
-
Do not expose the device to extreme dampness for longer periods of time.
-
Inadmissible bedewing (condensation of air moisture on the device) can occur
if a cold device is taken into a significantly warmer environment. In this case,
please acclimatise the device for approx. 2 hours at room temperature after it
has been disconnected from the mains.
Avoid static charging of the material to be weighed, weighing container and
-
windshield.
Major display deviations (incorrect weighing results) are possible if electromagnetic
fields occur as well as due to static charging and instable power supply. It is then ne-
cessary to change the location.
6.1.1 Installation
Use the foot screws to level the balance until the air bubble in the bubble level is in
the prescribed circle.
6.1.2 List of items supplied
Standard accessories:
- Balance including humidity
identifier attachment
- Tray holder
- 10 sampling trays
- Mains cable
MLB50-3-BA-defsi-0310
Available optional accessories:
- Aluminium trays (item no.:MLB-A01)
- Glass fibre filter (item no.:RH-A02)
- Temperature calibration set
- (item no.:MLB-A03)
35
Hide quick links:
Advertisement
Table of Contents
