Assembly - L.B. White CP125AK Owner's Manual And Instructions

Installation and Assembly Instructions

ASSEMBLY

TOOLS REQUIRED
- Medium Phillips screwdriver.
- M5 open, or adjustable wrench.
- Long nose pliers.
1. Slide axle through wheel support frame. Install wheel bushings and wheels on axle.
NOTE: When installing wheels, tube valve should face out from support frame (Figure 3).
2. Place flat washers and cotter pin on axle ends and bend cotter pins with long nose pliers to secure.
3. Place wheel cap on flat washers and put wheel cap in flat washers end.
4. Place heater on wheel support frame. Make sure the air inlet end (rear) of heater is over wheels. Align the holes on fuel
tank flange. Insert screws through handles (front and rear), fuel tank flange, and wheel support frame as shown in
Figure 4 and attach and nut finger tight after each screw is inserted.
5. After all screws are inserted, tighten nuts firmly.
6. Align the hole on the handle (front and rear) with the mounting hole on the cord wrap.
7. Insert screws through cord wrap, handles as shown in Figure 4 and attach nut finger tight after each screw is
inserted.
8. After all screws are inserted, tighten nuts firmly.
Wheels
Front Handle
Figure 4 – Component Identification
Fire or explosion hazard!
■ Do not operate heater without support frame fully
assembled to tank.
Model
Wheel Support Frame
Wheels
Cap-Wheel
Front-Handle
Rear-Handle
Axle
Cord Wrap
Hardware Kit
CP125AK / CP170AK / CP210AK
Screws L & S
Wheel Caps
Wheel Caps
Wheel Support Frame
WARNING
CP125AK CP170AK CP210AK
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Flange Screws
Washers
Cotter Pins
Axle
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Nuts Washers
Bushings
Rear Handle
4 8