RetroSound RetroRadio Apache User Manual page 6

PRECAUTIONS
• Refer wiring and installation to qualified service personnel.
Installation of this unit requires special skills and experience.
Retro Manufacturing, LLC is not liable for any problems
resulting from improper installation of the unit. Please be sure
to follow the instructions carefully while attempting installation.
• Follow the instructions to wire the unit. Failure to follow the
instructions could cause damage to the unit, fire, injury or death.
• Be careful not to damage the leads. Prevent them from
being caught in the vehicle chassis or from being damaged
by screws or moving parts such as seat rails. Do not scratch,
pull, bend or twist the leads. Do not install them near heat
sources or place heavy objects on them. If the wiring must
be routed around sharp metal edges, protect them by
wrapping them with vinyl tape or similar protections.
NOTE: Cutting the main wiring harness, antenna lead, USB or auxiliary cables will
void the warranty of your radio.
• We recommend only using the supplied parts when installing
this unit. If mounting the radio face or body remotely, use
extreme caution not to damage internal parts when
choosing brackets and screws.
• Do not interfere with safety-related vehicle components.
Do not wire or affix this unit to the fuel tank, brakes, suspension,
steering wheel, pedals, etc. Check for electric wiring, piping
and other items before installing the unit.
• Never install the unit in a location where it interferes with your
field of vision.
• Use the supplied metal backstrap to secure the rear of the
unit. Failure to secure the rear of the unit will damage the
shafts and void your warranty.
5