Usb Device Instructions - RetroSound RetroRadio Apache User Manual

USB DEVICE INSTRUCTIONS

Connecting a USB Device
The USB input is located at the rear of the radio body. The USB
cable must be routed to a convenient and accessible location for
plugging in USB devices.
Once you have turned on your radio and connected your flash
drive or supported USB device to the USB input, the radio will find
your songs and automatically begin playing them.
The icon appears on the LCD during USB playback.
To change songs, rotate the right-front knob (#4) to access the
next or previous song. To cycle through folders, turn the right-rear
knob (#3) clockwise, then rotate the right-front knob (#4) to cycle
through the folders. To play/pause, listen to 10 seconds of each
song ( ), repeat the track you're listening to (
INT
select from all songs on the attached flash drive or supported USB
device ( ), press the left-front knob (#1) to access the USB menu.
RDM
About MP3/WMA/FLAC
MP3 (MPEG Audio Layer-3) and WMA (Windows Media Audio)are
for compressed audio files. When your radio is in USB mode, you can
play MP3 and unprotected (no DRM) WMA files off the flash drive.
Common facts about these compressed-sound formats:
• High bit rate and high sampling frequencies are
recommended for high sound quality.
• Selecting VBR (Variable Bit Rate) is not recommended
because playing time is not displayed properly and there
may be some audible skipping artifacts. The playback sound
quality differs depending on the encoding circumstances. For
details, refer to the user manual of your encoding software.
) or randomly
RPT
Copyright © 2019 Retro Manufacturing, LLC
22