ICP DAS USA PETL Series User Manual page 60

Ethernet I/O Modules
The following table provides an overview of the parameters contained in the DIO Synchronization
section:
Item
Synchronous DIO (Local Mirror)
Level Sync (DO = DI)
Rising Active (DO = ON)
Falling Active (DO = ON)
Additional Controls
Min-Switch Time of DO
(0 to 65535 Seconds)
Auto-off Time of DO
(0 to 65535 Seconds)
Update Settings
ICP DAS CO., LTD.
This parameter is used to enable the synchronization operation in Digital
Input/Output function.
This parameter is used to enable rising active in Digital Input function.
When the specified DI state changed from OFF to ON, the corresponding
DO will be set to ON.
This parameter is used to enable falling active in Digital Input function.
When the specified DI state changed from ON to OFF, the corresponding
DO will be set to ON.
This parameter is used to set the minimum switching time between the ON
and OFF state of the Digital Output. This protects some machines from
being damaged by too many ON/OFF switches in a short time.
This parameter is used to set the auto-off time of the Digital Output. If the
Digital Output is ON, the Digital Output will be auto-off based on the
configured time value.
Click this button to save the revised settings of DIO configuration to the
PETL/tET/tPET module.
PETL/tET/tPET DIO Series User Manual, Ver. 2.2, Aug. 2017, Page: 60
Description