Accessory Installation - WEG CFW500 Series Installation, Configuration And Operations Manual

RS485 Communication Plug-in Module

4 ACCESSORY INSTALLATION

The accessory is easily installed or replaced. For correct
installation of the accessory execute the following steps:
Step 1: With the inverter power supply off, remove the
front cover of the Inverter (figureA.1 (a)).
Step 2: Remove the accessory (connected plug-in
module) if any, as in figure A.1 (a).
Step 3: Fit and press the accessory to be installed as
indicated in figure A.1 (b) and then assemble the front
cover of the inverter.
Step 4: Power up the inverter and check if parameter P0027
shows value 9 (P0027 = 9). If this information is not true,
check if the module used is actually the CFW500-CRS485
and repeat steps 1-4.
6 | CFW500