FIBARO ROLLER SHUTTER 3 Operating Manual page 27

34. Alarm configuration - 5th slot (Heat)
This parameter determines to which alarm frames and how the device
should react. The parameters consist of 4 bytes, three most significant
bytes are set according to the official Z-Wave protocol specification.
Available settings: 1B [MSB] - notification Type
Default setting:
Parameter size:
SCENE TIGGERING CONFIGURATION
40. S1 switch - scenes sent
This parameter determines which actions result in sending scene IDs
assigned to them.
Available settings: 1 - Key pressed 1 time
Default setting:
41. S2 switch - scenes sent
This parameter determines which actions result in sending scene IDs
assigned to them.
Available settings: 1 - Key pressed 1 time
Default setting:
2B - notification Status
3B - Event/State Parameters
4B [lSB] - action:
0 - no action
1 - open blinds
2 - close blinds
[0x04, 0xFF, 0x00, 0x00]
(heat Alarm, any notification, no action)
4 [bytes]
2 - Key pressed 2 times
4 - Key pressed 3 times
8 - Key hold down and key released
0
Parameter size:
2 - Key pressed 2 times
4 - Key pressed 3 times
8 - Key hold down and key released
0 Parameter size:
1 [byte]
1 [byte]
ADVAncED PARAMETERS
27
i
NOTE
Parameter 40 values
may be combined,
e.g. 1+2=3 means that
scenes for single and
double click are sent.
i
NOTE
Enabling triple click
for S1 in parameter 40
disables the ability to
add/remove via S1.
i
NOTE
Parameter 41 values
may be combined,
e.g. 1+2=3 means that
scenes for single and
double click are sent.