FIBARO ROLLER SHUTTER 3 Operating Manual page 7

Installation with gate motors:
• Installation of the gate driver may be performed only by certified
professionals.
• The motor must be equipped with the appropriate limit switches.
• It is recommended to connect a nc (normally closed) contact of
an IR barrier to S2 terminal. Opening the contact will stop the gate.
• In addition, it is recommended to connect an emergency stop
button to the motors neutral (n) wire. In emergency, pushing the
emergency stop button will cut the power and stop the gate.
1. Switch off the mains voltage (disable the fuse).
2. Open the installation box.
3. connect with the following the diagram:
PE
L
N
S1 S2 Q2
B
Shutter 3
Wiring diagram - gate motors
4. Verify if the device is connected correctly.
5. Arrange the device and its antenna in the installation box.
6. close the installation box.
7. Switch on the mains voltage.
sensor
NC
safety switch
limit
switches
L Q1 N
Roller
NC
N
M
7
InSTAllATIOn