What To Do After The Engine Starts - Honda CR-V 2019 Owner's Manual

Hide thumbs Also See for CR-V 2019:

Table of Contents

What to Do After the Engine Starts

Once your vehicle's engine has started, remove the jumper cables in the following

1. Disconnect the jumper cable from your vehicle's ground.

2. Disconnect the other end of the jumper cable from the booster battery -

3. Disconnect the jumper cable from your vehicle's battery + terminal.

4. Disconnect the other end of the jumper cable from the booster battery +

Have your vehicle inspected by a nearby service station or a dealer.

*1: Models with the keyless access system have an ENGINE START/STOP button instead of an

ignition switch.

* Not available on all models

5. Connect the other end of the second

jumper cable to the engine mounting bolt

(as shown). Do not connect this jumper

cable to any other part.

6. If your vehicle is connected to another

vehicle, start the assisting vehicle's engine

and increase its rpm slightly.

7. Attempt to start your vehicle's engine. If it

turns over slowly, check that the jumper

cables have good metal-to-metal contact.

1What to Do After the Engine Starts

The indicators for the Adaptive Cruise Control

/Adaptive Cruise Control (ACC) with Low

Speed Follow (LSF)

, road departure mitigation

system, Vehicle Stability Assist (VSA) system, VSA

OFF, Collision Mitigation Braking System (CMBS), low

tyre pressure/deflation warning system

brake and brake system (amber) may come on along

with a message in the driver information interface

when you turn the ignition switch to ON

reconnecting the battery.

Drive a short distance at more than 20 km/h (12

mph). The indicator should go off. If it does not, have

your vehicle checked by a dealer.

, and parking