Honda CR-V 2019 Owner's Manual page 120

Indicator Name
Collision
Mitigation
Braking System
(CMBS)
Indicator
*1:Models with the keyless access system have an ENGINE START/STOP button instead of an ignition switch.
On/Blinking
• Comes on for a few seconds when
you turn the ignition switch to ON
*1 , then goes off.
w (
• Comes on when you deactivate the
CMBS. A driver information
interface message appears for five
seconds.
• Comes on if there is a problem with
the CMBS.
• Comes on if the CMBS is deactivated
temporarily after the battery has
been disconnected, then re-
connected.
• Indicator may comes on temporarily
when the Maximum Load Limit is
exceeded.
• Comes on when the CMBS system
shuts itself off.
Explanation
• Stays on constantly without the
CMBS off - Have your vehicle checked
by a dealer.
2 Collision Mitigation Braking System
(CMBS) P. 561
• Drive a short distance at more than 20
km/h (12 mph). The indicator should go
off. If it does not, have your vehicle
checked by a dealer.
• Make sure the total load is within the
Maximum Load Limit.
2 Load Limit P. 503
• Stays on constantly - Have your
vehicle checked by a dealer.
• Stays on - The area around the camera
is blocked by dirt, mud, etc. Stop your
vehicle in a safe place, and wipe it off
with a soft cloth.
2 Front Sensor Camera P. 626
• Have your vehicle checked by a dealer if
the indicator does not go off even after
you cleaned the camera.
2 Collision Mitigation Braking System
(CMBS) P. 561
uuIndicatorsu
Message
—
Continued 119