ComAp InteliLite NT AMF 25 Operator's Manual page 5

MODE RIGHT button. Use this button to change the mode. The button works
only if the main screen with the indicator of currently selected mode is
displayed.
6
N
OTE
This button will not work if the controller mode is forced by one of binary
inputs Remote OFF, Remote MAN, Remote AUT.
GCB button. Works in MAN mode only. Press this button to open or close
7 the GCB manually. Note that certain conditions must be valid otherwise GCB
closing is blocked.
G - O
EN SET PERATION
P I D
OSITION NDICATOR ESCRIPTION
Gen-set failure. Red LED starts flashing when gen-set failure occurs. After FAULT
8 RESET button is pressed, goes to steady light (if an alarm is still active) or is off (if no
alarm is active).
Gen-set voltage OK. Green LED is on if the generator voltage is present and within
limits.
9 N :
OTE
The limits for the generator voltage and frequency are given by setpoints in the Gener
Protect group.
GCB ON. Green LED is on, if GCB is closed. It is driven by GCB CLOSE/OPEN
10
output (MRS 3/4/10/15) or by GCB feedback signal (MRS 11/16).
D C
ISPLAY AND ONTROL
P B D
OSITION UTTON ESCRIPTION
PAGE button. Use this button to switch over display pages. See Display
11
Screens and Pages Structure chapter below this table for more details.
12 UP button. Use this button to move up or increase a value.
13 DOWN button. Use this button to move down or decrease a value.
ENTER button. Use this button to finish editing a setpoint or moving right in
14
the history page.
15 Graphic B/W display, 128x64 pixels
IL-NT Operator Guide
©ComAp – December 2008
:
I
NDICATORS
B
UTTONS
5