Specification - KDS Flymentor 3D User Manual

place where the gyro should be.
· CCD: used to 'see' ground to avoid drifting. To see ground effectively, CCD should be
mounted on suitable place, and lens must face to the ground, and CCD must ' see' the
ground well without any obstruction.
KDS Flymentor 3D has following functions:
·Control all movement, including attitude stabilization, speed control, position locking.
·CCD sensor to capture picture of ground, comparing pictures to avoid drifting.
·Switch working mode (horizontal mode and position mode) through AUX channel.
·Integrating head locking gyro and swashplate mixer.
·Control sensitivity and mode of internal gyro through GEAR channel.
·Support swashplate 3S 12 0º, 3S 140º, 4S 90º, 4S 90º+4 5º
·Keep balance in inverted flight.
·Configured by computer through USB.
·If you are using FM/PPM remote control device, when helicopter is out of control, the
Flymentor 3D will set aileron, elevator, rudder to neutral, and keep pitch in the final signal
position, and switch to positioning mode automatically, the sensitivity is 70%.

1.2 Specification

·
Voltage: 4.8-6.0V
·Current: 55mA (under 5V)
·Weight:37G
·Temperature: 0℃~ +40℃
·Under the stabilisation mode and positioning mode, maximum rotate speed allowed:
√Aileron and Elevator: ≤200°/ s
√Tail turning (if using external gyro): ≤360°/ s
KDS Flymentor 3D User Manual
3