Gyro Settings - KDS Flymentor 3D User Manual

4.1.1 Gyro settings

1） Gyro sensitivity
The sensitivity of gyro can be set from -1 0 0 to + 1 0 0 . The positive value means the
gyro working under ' head lock' mode, negative value means the gyro working under
' normal mode'. It is recommended to use ' head lock' mode. Same as other gyros,
the sensitivity should be as large as possible until the tail swings.
If Flymentor 3D has connected the sensitivity channel of receiver, the setting in this page
will be disabled, the gyro of Flymentor 3D will use the signal from receiver as sensitivity
value. If you do not want to modify sensitivity value frequently, you can keep the
sensitivity channel empty (the blue line), then the channel on receiver can be used for
other using.
2） Yaw rate
This parameter controls the changing speed of direction. Normally, the value should be set
to maximum, but if you do not like fast changing of direction, you may adjust it as you want.
3） Yaw expotent
This parameter controls the exponent of rudder. Little value will cause fine response in slim
motion of stick. You may adjust it as you want.
4） Pitch to tail mix
This mix can improve effect when pitch changing. You can choose a suitable value to make
better response of gyro to pitch changing.
5） Servo travel limit
This parameter controls the signal for tail servo, to avoid mechanical conflict of tail pitch
structure .
KDS Flymentor 3D User Manual
22