Servo Reverse - KDS Flymentor 3D User Manual

3.4.1 Servo Reverse

You must set reverse before adjusting neutral. It is a little different from adjusting helicopter
without Flymentor 3D, the adjusting should be done in Flymentor 3D, not in transmitter!
Please do it as following steps:
1） Ensure Flymentor 3D is mounted, and all electronic devices have been connected
successfully.
2）Turn on transmitter, ensure throttle stick on lowest position.
3）Place helicopter on a horizontal surface, power up.
4）Wait for Flymentor 3D initialization finished.
5） Lean helicopter to one side, watch the reaction of swash plate. If servo reverse setting is
correct, the Flymentor 3D will control swashplate to the opposite side. That means when
helicopter lean to left, the swashplate should lean to right ( relative to main axis) ,
when helicopter lean to front, the swashplate should lean to rear, etc. See diagram
3.4.2.
Lean helicopter
to left side
6）If the reaction is wrong, connect Flyementor with computer, change reverse setting and save it. ( You
can keep connection when Lean-testing)
7）Repeat step 4, 5 until reactions of all directions are correct.
* Attention: to avoid injury, please unmount main rotor and shut off power!
KDS Flymentor 3D User Manual
Reaktion
Diagram 3.4.2 Correct Flymentor 3D reaction
17
Swash lean
to right