Stick Travel - KDS Flymentor 3D User Manual

2）Turn on transmitter, ensure throttle stick on lowest position.
3）Place helicopter on a horizontal surface, power up.
4）Wait for Flymentor 3D initialization finished.
5）Move each stick, record the reaction of swash plate.
6） If the reaction is wrong, connect Flymentor 3D with computer, change reverse setting
and save. (You can keep connection when do sticks- testing)
7）Repeat step 3, 4, and 5 until all reactions are correct.
* Attention: to avoid injury, please unmount main rotor and shut off power!

3.5.2 Stick travel

Set stick travel as following steps:
1) Ensure Flymentor 3D is mounted well, and all electronic devices have been connected
successfully.
2) Turn on transmitter, ensure throttle stick on lowest position.
3) Place helicopter on a horizontal surface, power up.
4) Wait for Flymentor 3D initialization finished.
5) Move each stick to its extreme position, record the move range of swash plate.
6) If the range is not suitable, connect Flymentor 3D with computer, change reverse setting
and save it. (You can keep connection when travel- testing)
7) Repeat step 3 , 4 and 5 until all reactions are correct.
* Attention: to avoid injury, please unmount main rotor and shut off power!
KDS Flymentor 3D User Manual
20