Mounting Stage; Setup Transmitter - KDS Flymentor 3D User Manual

When adjusting done, click 'Write' button (see diagram2.2.3) to save parameters.
Saving progress
The saving will take a few seconds, during saving, a bar will show to indicate the progress. If the
'Write' button is gray (disabled), it means the parameters you set is equal to parameters in
Flymentor 3D, and no necessary to write. If they are not equal, a exclamatory mark will
show to notify you.

3. Mounting stage

3.1 Setup transmitter

Normally, the transmitter of helicopter model might have mixer, but KDS Flymentor 3D has
internal mixer, so you must turn off the mixer of transmitter, and make it under the condition
of " no mixing helicopter mode", otherwise the Flymentor 3D can not work properly.
All mixers related to swashplate must be turned off, and travel of aileron and elevator should
Modify flag
Diagram2.2.3 Saving changes
KDS Flymentor 3D User Manual
'Write' button
11