Gyro Expert Setting; Adjusting 'Advance Parameters - KDS Flymentor 3D User Manual

4.1.2 Gyro Expert Setting

1） Sensor gain
The parameter controls the gain of signal amplifier. You may not modify it in most case.
2） Tail delay
The parameter is used to fit feature of tail servo. The response speed of tail servo is
slower, the parameter should be set larger. If some high quality servos are used, you
should set a little value, such as 0.
3） Head holding angle range
The parameter controls the inertia of turning. The inertia means the extra rotation when you
make a direction turning.
When you begin moving the rudder stick, it will cause a rotation (head direction changing of
the helicopter), when you stop moving the rudder stick, the helicopter will not stop rotation
immediately because of the inertia, it will rotate an extra angle before stopping. The
parameter controls the angle.
4.2 Adjusting 'Advanced parameters'
The page controls working mode of Flymentor 3D. It is strongly recommended to keep them as
factory setting when you do not know them well.
KDS Flymentor 3D User Manual
23