Mounting Flymentor 3D - KDS Flymentor 3D User Manual

3.2 Mounting Flymentor 3D

Firstly you should find a suitable place to mount Flymentor 3D. The lens of CCD should face to
the ground, and the Sensor should be mounted on the place where gryo was assembled,
see diagram 3.2.1 for example. The controller can be mounted in any place you want.
Mount CCD
helicopter,
the ground, the arrow point
to front.
*Attention: the arrow on CCD and the arrow on Sensor must point to same direction
After mounting of Flymentor 3D, all electronic devices should be connected. There is a
internal gyro in Flymentor 3D, so additional gyro is not necessary. Diagram3.2.2 is an
example, the connection between receiver and controller should refer to following table.
at side of
lens face to
Diagram 3.2.1
KDS Flymentor 3D User Manual
Mount Sensor on flat at tail
(or bottom of flat),the arrow
point to front.
A mounting example
13