Emerson Network Power MPH2 User Manual page 7

CAUTION
!
All configuration steps must be completed before attempting to start equipment connected to the
MPH2 Rack PDU.
NOTE
!
For power management purposes, record the receptacle where each piece of equipment is
connected. Receptacles on the MPH2 Rack PDU have a numeric designation. The MPH2 Rack
PDU identifies the receptacles with numbers and are grouped by branch with a letter referring to
the proper circuit breaker.
EUROPEAN UNION
Notice to European Union Customers: Disposal of Old Appliances
This product uses components that are dangerous for the environment, such as
electronic cards and other electronic components. Any component that is removed
must be taken to specialized collection and disposal centers. If this unit must be
dismantled, this must be done by a specialized center for collection and disposal
of electric and electronics appliances or other dangerous substances. This product
has been supplied from an environmentally aware manufacturer that complies with
the Waste Electrical and Electronic Equipment (WEEE) Directive 2002/96/EC. The
"crossed-out wheelie bin" symbol at right is placed on this product to encourage
you to recycle wherever possible.
Please be environmentally responsible and recycle this product through your
recycling facility at its end of life. Do not dispose of this product as unsorted municipal waste. Follow local
municipal waste ordinances for proper disposal provisions to reduce the environmental impact of waste
electrical and electronic equipment (WEEE).
For information regarding the scrapping of this equipment, go to http://www.eu.emersonnetworkpower.com
("Products session" or "Contact us" session) or call Emerson's worldwide technical support at:
• 00 80011554499 (toll free number)
• +39 0298250222 (toll number based in Italy)
ROHS Compliance
The MPH2 Rack PDU modules comply with the Restriction of Hazardous Substances directive (ROHS),
prohibiting use of six hazardous materials manufacturing of electronics, including lead-free solder.
FCC Compliance
This unit complies with the limits for a Class A device pursuant to Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired
operation.
NOTE
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio
communications.
Operation of this equipment in a residential area is likely to cause harmful interference that the
user must correct, including the expense of all corrective modifications.
2
Important Safety Instructions
® ™
Emerson MPH2 User Manual