Installing A Mph2 In An Emerson Rack; Mounting Hardware And Tools Required; Mounting The Vertical Mph2 - Emerson Network Power MPH2 User Manual

Installation
2.3 Installing a MPH2 in an Emerson
2.3.1

Mounting Hardware and Tools Required

Factory-supplied
• 2 mounting brackets
• 2 mounting buttons
• 4 spring nuts
Field-supplied
For mounting a vertical MPH2
• Phillips #2 screwdriver
For mounting a horizontal MPH2:
• Flat-blade screwdriver
• Torx screwdriver TX30
• Torque wrench
2.3.2

Mounting the Vertical MPH2

The vertical MPH2 can be installed on a vertical or horizontal frame member in the rack.
1. Determine where in the Emerson rack the PDU will be installed.
2. Attach a bracket to each end of the PDU.
3. If mounting on horizontal frame members, attach the brackets in-line, Figure 2-4.
- or -
If mounting on a vertical frame member, attach the brackets at a right angle to the PDU.
4. Insert two spring nuts into the appropriate T-slot on the frame member, Figure 2-4. Position the spring
nuts to accommodate screws inserted through slots in the brackets. To move the spring nuts, press
down on each with a small, pointed object and slide each into position.
5. Hold the PDU in place and attach the top of the unit to the rack with tool-less fasteners, Figure 2-4.
® ™
Emerson MPH2 User Manual
Rack
®
15