Table 3-1 Factory-Default Settings - Emerson Network Power MPH2 User Manual

The default settings described in Table 3-1 apply only to MPH2, are set at time of manufacture and are
applied when "Restore to Factory Defaults" is initiated via RPC2 clients.
NOTE
For detailed information about settings and about network- and protocol-
related default settings for RPC2, see SL-20841. The document is available at
Emerson's Web site:
Level Settings
User Assigned Label
Asset Tag 1
Asset Tag 2
Overcurrent Alarm Threshold
PDU
Overcurrent Warning
Threshold
Undercurrent Alarm Threshold 0
Unbalanced Load Alarm
threshold
Software Over Current
Protection (SWOCP)
User Assigned Label
Asset Tag 1
Asset Tag 2
Overcurrent Alarm Threshold
Overcurrent Warning
Branch
Threshold
Undercurrent Alarm Threshold 0
SWOCP
http://www.emersonnetworkpower.com
Table 3-1 Factory-default settings
Default Value Units
MPH2 or
Rack PDU —
<alpha>
<empty> —
<empty> —
45 %
40 %
%
0 %
Disabled —
Branch <alpha> —
<empty> —
<empty> —
95 %
90 %
%
Disabled —
30
Models
Affected
• RackPDU is default value the first time
All
only.
• Allowed characters include
All
alphanumeric, space,
and ~!#$_+`-={}|[]\\:;'?,.\/%^&*()@
All
All
• % calculated from maximum input-
current rating on nameplate.
All
• Default values are recommended for
dual-corded server applications.
All
All % difference calculated between any two
3-phase phases.
Conditionally applies to unlocked and
R
unloaded receptacles only.
All
Allowed characters include
All alphanumeric, space,
and ~!#$_+`-={}|[]\\:;'?,.\/%^&*()@
All
All
% calculated from CB rating. Refer to
All nameplate for maximum branch current
rating.
All
Conditionally applies to all unlocked and
R unloaded receptacles only for this
branch.
Emerson
Operation
Notes
® ™
MPH2 User Manual