AEG CGB6133CCM User Manual page 25

Dimensions
Width
Depth
13.2 Location of the appliance
You can install your freestanding
appliance with cabinets on one or two
sides and in the corner.
For the minimal distances of fitting check
the table.
A
D
Minimum distances
Dimension mm
A 650
B 450
C 2
D
400
E 150
F less than 400
13.3 Levelling of the appliance
600 mm
609 mm
E
F
B
C
Use small feet on the bottom of
appliance to set the appliance top
surface level with other surfaces.
13.4 The stability chain
CAUTION!
Install the stability chain to
prevent the appliance from
tilting. The stability chain
only works when the
appliance is put in a correct
area.
1. Measure down 180 mm from the
appliance top surface, then measure
right 30 mm.
2. Mark the position of the wall and this
gives anchor point for the stability
chain.
30 mm
13.5 Other technical data
WARNING!
These instructions are only
valid in the countries whose
symbols appear on this
booklet's cover.
Gas category:
Gas supply:
Voltage:
Frequency:
ENGLISH 25
180 mm
I2H
G20 (2H) 20 mbar
220-240 V
50 Hz