AEG CGB6133CCM User Manual page 10

10 www.aeg.com
WARNING!
Be very careful when you use
open fire in the kitchen
environment. The
manufacturer declines any
responsibility in case of the
flame misuse.
1. Turn the knob for the hob to the
position
you push the knob, the spark
generator activates automatically.
2. Keep the knob for the hob pushed
for equal or less than 10 seconds to
let the thermocouple warm up. If not,
the gas supply is interrupted.
3. Adjust the flame after it is regular.
WARNING!
Do not keep the knob
pushed for more than 10
seconds. If the burner does
not light after 10 seconds,
release the knob, turn it into
the off position and try to
light the burner again after
minimum 1 minute.
If after some tries the burner
does not light, check if the
crown and its cap are in the
correct position.
5.2 Burner overview
G
F
and push it down. When
In the absence of electricity
you can ignite the burner
without an electrical device.
In this case approach the
burner with a flame, push
the relevant knob down and
turn it to maximum position.
Keep the knob pushed for
equal or less than 10
seconds to let the
thermocouple warm up.
If the burner accidentally
goes out, turn the knob to
the off position and try to
light the burner again after
minimum 1 minute.
The spark generator can
start automatically when you
switch on the mains, after
installation or a power cut. It
is normal.
A. Burner cap
A
B. Burner crown
C. Slots
D. Thermocouple
E. Ignition candle
F. Burner body
B
G. Hole for the ignition candle
C
D
E