ZyXEL Communications XMG3512-B10A User Manual page 85

The following table describes the general wireless LAN labels in this screen.
Table 17 Network Setting > Wireless > General
L ABEL DESC RIPT IO N
Wireless Network Setup
Band This shows the wireless band which this radio profile is using.
802.11b/g/n wireless clients while
Wireless You can
Channel Use
Auto
Bandwidth Select whether the XMG uses a wireless channel width of
A standard 20MHz channel offers transfer speeds of up to 150Mbps whereas a 40MHz channel
uses two standard channels and offers speeds of up to 300 Mbps.
40MHz (channel bonding or dual channel) bonds two adjacent radio channels to increase
throughput. The wireless clients must also support 40 MHz. It is often better to use the 20 MHz
setting in a location where the environment hinders the wireless signal.
An 80MHz channel groups adjacent 40MHz channels into pairs to increase bandwidth even
higher.
Select
20MHz
neighborhood or the wireless clients do not support channel bonding.
Control This is available for some regions when you select a specific channel and set the Bandwidth field
Sideband to
40MHz
range of channel bands.
Uppe r
Wireless Network Settings
Wireless The SSID (Service Set IDentity) identifies the service set with which a wireless device is associated.
Network Name Wireless devices associating to the access point (AP) must have the same SSID.
(SSID)
Enter a descriptive name (up to 32 English keyboard characters) for the wireless LAN.
Max Clients Specify the maximum number of clients that can connect to this network at the same time.
Hide SSID Select this check box to hide the SSID in the outgoing beacon frame so a station cannot obtain
the SSID through scanning using a site survey tool.
Multicast Select this check box to allow the XMG to convert wireless multicast traffic into wireless unicast
Forwarding traffic.
Max. Upstream Specify the maximum rate for upstream wireless traffic to the WAN from this WLAN in kilobits per
Bandwidth second (Kbps).
Max. Specify the maximum rate for downstream wireless traffic to this WLAN from the WAN in kilobits
Downstream per second (Kbps).
Bandwidth
BSSID This shows the MAC address of the wireless interface on the XMG when wireless LAN is enabled.
Security Level Select
Ba sic (WEP)
wireless clients which want to associate to this network must have same wireless security settings
as the XMG. When you select to use a security, additional options appears in this screen.
Or you can select
encryption or authentication.
See the following sections for more details about this field.
Apply Click
Apply
Cancel Click
C a nc e l
Chapter 7 Wireless
5G Hz
or the wireless LAN in this field.
Ena b le Disa b le
to have the XMG automatically determine a channel to use.
if you want to lessen radio interference with other wireless devices in your
. Set whether the control channel (set in the
or
Mo re Se c ure (WPA(2)- PSK)
to allow any client to associate this network without any data
No Se c urity
to save your changes.
to restore your previously saved settings.
XMG3512-B10A User's Guide
85
is the frequency used by IEEE
2.4G Hz
is used by IEEE 802.11a/ac wireless clients.
,
20MHz 40MHz
field) should be in the
C ha nne l
to add security on this wireless network. The
or .
80MHz
or
L o we r