Procopi ProSwell Weva octo 440 Installation Instructions Manual page 20

»
INSTALLATION INSTRUCTIONS
ASSEMBLING AND INSTALLING THE STAINLESS STEEL LADDER
> >
72
Assemble the various parts of the ladder referring to the
installation instructions provided.
When mounting the hand rails, do not forget the two
rubber seals that will be used to hold the decorative
escutcheon plates in position.
If the pool is fitted with in-pool corner steps, refer to the
installation instructions enclosed with this item.
ASSEMBLING AND POSITIONING THE WOODEN LADDER
> >
74
20
proswell.fr
/ OCTO & OCTO+
seal
escutcheon
plate
screwed
flange
73
Position the ladder in the pool on the coping module of
your choice (except the wall holding the filtration system
and counter swim module), remember that it should be
opposite the wooden ladder.
Adjust the position of the ladder paying particular
attention to ensure that it is vertical and that the bumpers
are pressed firmly against the inside wall.
Mark the positions for drilling. Remove the ladder and drill.
Fix the ladder in place according to the instructions
provided, the counter plate should be positioned under
the coping. Tighten moderately. Slide the 2 rubber seals
along the tubes so that they hold the escutcheon plates in
position.
The stringers and the treads for the
wooden steps are in the Wood kit.
Assemble the wooden steps using the SS
screws (bag K). For cleaner, more efficient
assembly, we recommend that you pre-
drill the various elements (4 mm drill bit)
and mill the holes to avoid splitting the
wood and raising splinters.