Advertisement
PK-88 OPERATING MANUAL
DIGIPEAT
Parameters:
ON
-
Equivalent to DFROM ALL
OFF -
Equivalent to DFROM NONE
In host computer applications that use a Boolean parameter switching routine rather
than numeric values, the DIGIPEAT command can be used with ON and OFF instead of ALL
or NONE.
This alternate DIGIPEAT command is appropriate in certain electronic mail and bulletin
board systems.
Note that DIGIPEAT ON and OFF as Boolean commands do not provide the same capability
for selective digipeating as with DFROM YES(calls) and DFROM NO(calls).
DISCONNE
DISCONNE is an immediate command that initiates a disconnect request to the station to
which you are connected.
If your disconnect command is successful, your monitor will display:
DISCONNECTED: (call sign)
Other commands can be entered while a disconnect is in progress. New connections are
not allowed until the disconnect is completed.
•
If the retry count is exceeded while waiting for the distant station to
acknowledge your disconnect command, your PK-88 switches to the disconnected
state.
•
If another disconnect command is entered while your PK-88 is trying to
disconnect, the retry count is immediately set to the maximum number. In either
case, your monitor displays:
*** Retry count exceeded
*** DISCONNECTED: (call sign)
Disconnect messages are not displayed when the PK-88 is in the Transparent Mode.
Mnemonic: DIG
Mnemonic: D
5-41
COMMAND SUMMARY
Default: ON
Immediate Command
PK88-123
Advertisement
