Advertisement
PK-88 OPERATING MANUAL
MDPROMPT text
Parameters:
ON
-
Monitor a calling station's activity on your MailDrop
OFF -
Normal monitoring as determined by the monitoring mode commands
MDPROMPT (text) is the command line sent to a calling station by your MailDrop, and is
similar to the command prompts sent to a calling station by a full-service packet BBS.
This prompt has no connection with BTEXT and is sent only to a logged-on caller.
You can install any 'personalized' text with a maximum length of 80 bytes. The minimum
command string is MDP. The default prompt is:
"Enter message, ^Z (CTRL-Z) to end"
MEMORY 'n'
Parameters:
n -
a hexadecimal address used with the ADDRESS and 1/0 commands to access the
PK-88's memory and 1/0 locations, or to read values stored at a specified
address.
The MEMORY command permits access to memory and 1/0 locations.
To use the Memory command:
•
Set the memory address into the ADDRESS command.
•
Use the MEMORY command without arguments to read memory locations one after
another.
•
Use MEMORY with one argument O-$FF to write to memory locations. After each
MEMORY command, the PK-88 adds 1 to the value of the ADDRESS.
PK-88 RAM locations are $8000-$FFFF. ROM begins at $0000.
The MEMORY command increments the ADDRESS counter by I each time MEMORY is typed.
Mnemonic: MDP
Mnemonic: ME
5-60
Default: (see text)
Default: none
COMMAND SUMMARY
PK88-142
Advertisement
