Product Identification; Installation - Prince Castle EHB Series Operation Manual

Extend Holding Bin
EHB Series
LED TIMERS ( tri-color)
(1 for each pan arrow button)
BUTTON BAR
PRINCE CASTLE
LOGO Button
Remove the unit from the carton and inspect for signs of
1
damage. If there is damage to the unit:
• notify the carrier within 24 hours of delivery
• save carton and packaging materials for inspection pur-
poses
• contact your local dealer, or if purchased directly,
the Prince Castle Sales Department at 800-722-7853
or 1-630-462-8800 to arrange for a replacement unit.
NOTE: Plug the power cord into the proper electrical
receptacle. All electrical connections must be in accordance
with local electrical codes and any other applicable codes.
Place Extend Holding Bin on flat surface.
2
Remove blue and/or white protective covering.
NOTE: When installing this unit, the ambient temperature
at the mounting site should not exceed 100°F (38°C)
Printed in USA 04/16 © 2016

Product Identification

TRANSFER Button
(Not used)
PAN ARROW Buttons UPPER PAN Display
(2 for each slot wide) (1 for each slot wide)

Installation

PAN LIDS, ONLY used with broiled products.
(Fried products DO NOT require lids)
Temperature
Control Panel
Button Bar
Power
ON/OFF
Switch
UP and DOWN ARROW
LOWER PAN Display
(1 for each slot wide)
Plug unit into a grounded
3
receptacle with a matching
plug configuration.
All electrical connections must be in accordance with local
electrical codes and any other applicable codes.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent, or similarly qualified persons
in order to avoid a hazard.
To prevent an electric shock hazard this device must be
bonded to equipment in close proximity with an equipotential
bonding conductor. This device is equipped with a grounding
lug for this purpose.
4
ENTER Button
REG LED
(Regular Menu)
WARNING:
540-537revG-EN
BKFT LED
(Breakfast)