Calibrating The Heaters - Prince Castle EHB Series Operation Manual

The display will now show SET LWR XXXX ###s ↑ ↓. Use the UP and DOWN arrows to set the temperature of the Lower heater of that zone.
4
Press MENU/ENTER to confirm setpoint temperature.
NOTE: Changing the profile on one bar in a linked system of bin (s) is enough, it does not need to be changed on all bars in the
system.
Press PRINCE CASTLE LOGO BUTTON to save the setpoints. Repeat steps 2-5 for all necessary profile upgrades.
5
NOTE: Setpoints are displayed on the front display board, and should be updated according to the product at this point.
Use the following steps to calibrate the individual heaters
1
Select ACTUAL TEMP. Press the UP or
DOWN Arrow button until the desired
shelf LED and upper or lower heater is
selected.
NOTE: Allow sufficient amount of time
for temperatures to stabilize before
Take a temperature reading within the shelf near
2
the center of each heater surface.
WARNING:
HOT SURFACES
Use caution when taking
temperature readings
within the shelf.
NOTE: Use an independent temperature meter (not supplied).
Press and hold the CROWN BUTTON and ACTUAL TEMP buttons
3
for 5 seconds. The colon (:) LED indicator will light. The temperature
displayed is the actual heater temperature sensed by the controller.
540-537revG-EN
Setting the Temperature (Continued)
Calibrating Heaters
9
Extend Holding Bin
Press the UP or DOWN Arrow button until the temperature
4 displayed matches the reading obtained in Step 2.
Press the CROWN BUTTON to save the temperature value and exit
the Calibration Mode. To undo changes before saving, press the
SETPOINT button. This clears the offsets entered.
Selecting Day Part
1 Press and hold the SETPOINT button
and the DOWN Arrow button for
3 seconds to change Day Part to
change the menu.
NOTE: Only applicable in stand-
alone mode when not connected to
Product Management system.
NOTE: The display will show
DAY # if the daypart has been
successfully changed.
NOTE: Whenever a bin is powered
ON it defaults to DAY PART 1 no
matter what time of day it is.
**For more info, see Menu Setup Manual 540-550**
Printed in USA 04/16 © 2016
EHB Series
NOTE: On the 3x4
unit, during calibration,
a HOLD message will
appear on the display.
When it does, release
all buttons until it
disappears, then
continue.