Changing Product Names - Prince Castle EHB Series Operation Manual

The EDIT PRODUCT NAME menu is used to change a default product name to one of your own choosing.
1
Press and hold the PRINCE CASTLE LOGO button on the button bar,
then immediately press and hold the ENTER button until the display shows one of six programming menus.
Use the UP or DOWN Arrow button to scroll to the PROD NAME ↑ ↓ ENTR (Edit Product Name) menu.
NOTE: Only applicable in stand-alone mode when not connected to Product Management system.
NOTE: The default menu items and names are listed on page 13.
Press and release the ENTER button to enter the Edit Product Name menu.
2
Use the UP or DOWN Arrow button to scroll through the list of products.
When the desired product is displayed, press the ENTER button to select it.
The first letter (in this case, the B ) will start blinking.
To change the blinking B, use the UP or DOWN Arrow button to scroll to the desired letter/number/symbol.
3
When the desired selection is displayed, press the PAN Arrow button to move to the next digit. Repeat for all digits.
NOTE: Holding the UP or DOWN Arrow button for longer than 2 seconds will cause the display to automatically scroll up or down.
When all four digits have been changed, press the ENTER button to select the new name.
4
The display will show PROD NAME ↑↓ ENTR. Repeat Steps 2 – 4 for any other product.
5
Press and release the PRINCE CASTLE LOGO button at any time to exit the Program Mode and return to the Run Mode.
NOTE: If the ENTER button has not been pressed to save any changes, the program will revert to the original names.
540-537revG-EN
Changing Product Names (Standalone Mode)
...
11 Printed in USA 04/16 © 2016
Extend Holding Bin
EHB Series