Broadcastvision Entertainment AudioFetch Express User Manual page 17

Hide thumbs Also See for AudioFetch Express:
Table of Contents

Advertisement

warning will persist until one of the following occurs
Restore button is clicked
o
Save Settings button is clicked and OK is clicked in the warning dialog
o
·
There is a "Restore" button that undoes all the changes
·
A warning dialog will automatically display if the Save Settings button is clicked and any required settings are
missing
For example: if encryption has been enabled but no password entered
o
The lower section of the NETWORK SETUP page configures settings of the internal AudioFetch audio
server. Check "Use Automatic IP Address" to have the AudioFetch audio server receive its' IP address
automatically (from the network's DHCP server), this is the recommended setting. Or uncheck and
enter values for: Manual IP Address, Subnet Mask, and Gateway
The values must be correct for operation with the connected network, contact your IT network
administrator for instructions if needed.
Usually it is best to leave "Use Automatic IP Address" enabled and let the network's DHCP server
assign an IP address. It is not necessary to enter a manual IP address when the network's DHCP server
has been configured with a reservation IP address for the AudioFetch Box, just leave Use Automatic IP
Address enabled – the DHCP server should be able to assign the reserved IP address based on the
AudioFetch Express's MAC address.
IMPORTANT NOTE FOR IT PERSONNEL: In Wireless Client networking mode, the AudioFetch Express
will present two distinct clients to the pre-existing WiFi network. One client is the internal WiFi
module (operating in a bridging mode) and the other client is the AudioFetch Express device (which
serves the audio). Both clients will request (and should receive) individual IP addresses from the
DHCP server. If using Wireless Client mode and experiencing connectivity issues please request the
AudioFetch App Note: "AudioFetch Express Wireless Client Networking Info,"
greater detail. Contact AudioFetch Technical Support if further assistance is required.
Enable checkbox for automatic
settings (recommended)
If checkbox not enabled, then
make these entries:
Enter desired
manual/fixed IP address
Enter desired subnet mask
Enter desired gateway IP
address
which explains in
17

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AudioFetch Express and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents