Broadcastvision Entertainment AudioFetch Express User Manual page 16

Important points when using the NETWORK SETUP page to reconfigure the network settings:
·
Changing to a new Networking Mode will almost certainly cause your browser to disconnect from the
Doghouse (after clicking the "Save Settings" button)
You will need to reconnect your PC/device to the AudioFetch Express via the new networking mode,
o
in order to re-establish access to the Doghouse (just like starting from scratch)
·
Any mistake made in the settings, could cause the AudioFetch Express to become inaccessible after the "Save
Settings" button is clicked
·
For any problem, best course of action is:
Use the red External Button to restore factory defaults in the Wi-Fi Module as described in section 10
o
Restoring Factory Defaults with External Button
Reconnect to the default AudioFetch Express Access Point (SSID: AudioFetchExpress)
o
Access the Doghouse
o
Start over again entering the desired new network configuration settings
o
Steps to reconfigure the network mode:
1. Connect to the AudioFetch Express (AFE) and access the Doghouse via the current networking mode
a. In Access Point mode: Access the Doghouse through the AFE's Wi-Fi network
b. In Access Point & Wireless Internet mode: Access the Doghouse through the AFE's Wi-Fi network
c. In Wireless Client mode: Access the Doghouse through the pre-existing Wi-Fi network
d. In Wired Only mode: Access the Doghouse through the pre-existing wired or Wi-Fi network
2. Adjust the desired settings
a. Nothing is activated or saved until the "Save Settings" button is clicked
3. Carefully review the settings
4. Click the "Save Settings" button and review the warning dialog that pops up
5. Click the "OK" button in the warning dialog
a. The Status LEDs to begin a "marching" pattern to indicate the save is still in- progress. The march will
be: yellow, green, red, repeat....
b. The save will take some time, be patient and do not disconnect power
c. Then the AudioFetch Express will automatically restart and should begin operating in the new mode
6. After the reboot, the new networking mode should be active and if correctly configured the status LEDs should
indicate the ready condition
7. If any problem after the reboot (ie: new networking mode doesn't seem to work), then:
a. Try is a power cycle (wait at least 35 seconds after cycling power before trying to access again)
b. Use the red External Button to restore factory defaults in the Wi-Fi Module as described in section 10
Restoring Factory Defaults with External Button, then repeat this procedure
The NETWORK SETUP page is designed to be as foolproof as possible:
·
Only those settings applicable for the selected Networking Mode will be available for editing (automatically
grayed out if not applicable)
·
Once any setting is changed, a warning notice will appear that the new settings have not been saved. This
16