To Prepare the Oscilloscope for Use
To Remove the Front Panel Cover
Before using the oscilloscope, remove the front panel cover. Grasp the
transverse tabs on each side and pull them outward to remove the cover.
Front Panel Cover
Figure 4 To Remove the Front Panel Cover
To Connect to Power Supply
This oscilloscope supports two kinds of AC input power supplies: 100 V-127 V,
45 Hz-440 Hz; 100 V-240 V, 45 Hz-65 Hz. Please use the power cord supplied
with the accessories to connect the oscilloscope to the AC power source, as
shown in the figure below. After you turn on the power switch, the oscilloscope
is connected to power, and the Power key
of the front panel is blinking.
DS4000E Quick Guide
Figure 5 To Connect to Power Supply
Transverse Tab
located at the lower left corner
Power Supply
Connector
Power Switch
RIGOL
English
11