Terminal Connection For Rs232; Ethernet Connection For Remote User Control; Connect Extra Device; Figure 8- Ethernet And Rs232 Terminal Connection - NTI RACKMUX Series Installation Manual

NTI RACKMUX-D17HR-N-SUSBHD4 RACKMOUNT DRAWER WITH QUAD SCREEN MULTIVIEWER

Terminal Connection for RS232

If control via serial connection is going to be used, serial control can be achieved by connecting a control terminal to the "RS232"
port .
To use the "RS232" port, connect one end of a CAT5 patch cable (supplied) to the port labeled "RS232" on the rear of the
SPLITMUX. Plug the other end of the CAT5 cable into an RJ45-to-DB9F adapter (supplied), and connect the adapter to the
RS232 port on the control terminal.

Ethernet Connection for Remote User Control

To make a remote connection, over the Ethernet, from anywhere on the local area network, connect a CAT5/5e/6 Ethernet
cable with RJ45 male connectors on the ends, wired straight through (pin 1 to pin 1, pin 2 to pin 2, etc.).
connect to the SPLITMUX using the Ethernet at a time.
Note: Alternatively, a direct connection from a computer's Ethernet port to the SPLITMUX "ETHERNET" port may also
be made using the same cable.

Connect Extra Device

On the front of the RACKMUX is an additional USB Type A port to be used, if desired, for an extra accessory. Any low or full
speed USB device may be connected to this port to be used.
Note: In order for the optional USB device port to be usable, the USB port on the rear of the RACKMUX must be
connected to a USB enabled CPU (a 2 meter USB cable is supplied).
Note: If a USB keyboard or mouse is connected, operation of the RACKMUX keyboard or mouse may cause
unpredictable results. Do not try to use both mice or both keyboards at the same time.
Connect optional USB 1.1 or 2.0 device
CAMERA
PRINTER

Figure 8- Ethernet and RS232 Terminal Connection

FRONT VIEW OF RACKMUX-V17
SCANNER

Figure 9- Connect a USB 1.1 device to the front (optional)

This port is fully compliant with USB standard 1.1.
FLASH DRIVE
7
Up to 8 users can
Note: If a USB 2.0 device is
connected to the optional
USB device port, it will
operate at USB 1.1 speed.