Terminal Connection For Rs232; Connect Extra Device; Figure 8- Rs232 Terminal Connection; Figure 9- Connect A Usb 1.1 Device To The Front (Optional) - NTI RACKMUX Series Installation Manual

NTI RACKMUX-4K17-N-16HD4K RACKMOUNT DRAWER WITH 4K VIDEO USB KVM SWITCH

Terminal Connection for RS232

If control via serial connection is going to be used, serial control can be achieved by connecting a control terminal to the "RS232"
port .
To use the "RS232" port, connect one end of a CAT5 patch cable (supplied) to the port labeled "RS232" on the rear of the
UNIMUX. Plug the other end of the CAT5 cable into an RJ45-to-DB9F adapter (supplied), and connect the adapter to the RS232
port on the control terminal.

Connect Extra Device

On the front of the RACKMUX is an additional USB Type A port to be used, if desired, for an extra accessory. Any low or full
speed USB device may be connected to this port to be used.
Note: In order for the optional USB device port to be usable, the USB port on the rear of the RACKMUX must be
connected to a USB enabled CPU (a 2 meter USB cable is supplied).
Note: If a USB keyboard or mouse is connected, operation of the RACKMUX keyboard or mouse may cause
unpredictable results. Do not try to use both mice or both keyboards at the same time.

Figure 8- RS232 Terminal Connection

Figure 9- Connect a USB 1.1 device to the front (optional)

This port is fully compliant with USB standard 1.1.
7
Note: If a USB 2.0 device is
connected to the optional
USB device port, it will
operate at USB 1.1 speed.