Power Supply (Nba-5111) (Option) - JRC JMA-5312-6/6HS Installation Manual

•
Rotation signal input (already pulled up at 470 ohm)
Connect the rotation signal line to the following terminals located on the terminal board:
TB4310-BP
TB4310-BPE
Since the radar JMA-5300MK2 does not detect the rotation direction, only one type of encoder input,
BP, is necessary.
Connect the rotation reference signal line to the following terminals located on the terminal board:
TB4310-BZ
TB4310-BZE
Both signal lines have been pulled up at 470 ohm, therefore, an open collector can be connected on
the output side.
3.13

POWER SUPPLY (NBA-5111) (OPTION)

If the ship's mains are alternating current, use the power supply. The power supply can be used for both
AC100-120 V and AC200-240 V of the ship's mains, but the input connector and the connecting bar must
be changed.
Input connector
INPUT VOLTAGE
CN105 CN104 1-2 2-3 4-5
AC100V
AC105-110V
AC115-120V
AC200V
○
AC210-220V
○
AC230-240V
○
3-24
Connecting bar
○ ○
○ ○
○ ○
○
○
○
3